How do I attach the extension table to my phoenix frame?

Posted by on February 27, 2012

  Your Extension table for the Phoenix Frame comes with the table and two brackets to hold the table to the machine. These instruction will help you get the table ready and the brackets in place so that you can attach the table and start using your rulers.

1. Removing the four leg parts from the Extension Tables.

a. You may want to use some needle nose pliers or a

socket to hold the nut on the bottom side with the black leg part, and a phillips screwdriver.

b. Remove the leg parts

c. Save the screws from the legs as you will be using these parts to secure the table to the brackets.

 2. Placing the brackets on the carriage next to the machine.

a. Loosen the front screws holding the carriage to the machine.

b. Looking at the brackets you will see four tabs

1. Two tabs have nuts attached to the bottom this is the top of bracket attach to bottom of table

2. Two tabs are blank these slid under the side of the machine.

c. Angle the bracket towards the back of the machine and slide between the machine and the carriage.

d. With the tab below the side of the machine slide the bracket forward so that you can get the front tab below the machine.

e. Slide the bracket back so that both bottom tabs are below the machine.

 3. Setting the table on and securing to the brackets.

a. Place the table on top of the brackets and line up the screw holes with the top tabs.

b. Using the screws you removed from the table in step

1. Secure the table to the brackets at the four (4) points.

c. Once the screws are secure slide the table and brackets back so that the table is against the machine.

d. Tighten the front screws on the carriage which secure the machine to the carriage.

You are now ready to use the extension table with your rulers while you are quilting.

To remove you will want to reverse the steps and remove the table first then the brackets.

Note: If you remove the machine first the table will fall as it is not attached to the machine.

Filed under: Blog,Lizzie Support | Tags: , , , , ,

Announcing the New Ruler Foot!

Posted by on October 11, 2011

You asked for it TinLizzie18 Listened!

Announcing the New RULER FOOT now available.

With the New Ruler foot using the many different rulers to enhance your quilt just got easier. Not only does the ruler foot have a fence on the edge but it also gives you more visibility of the needle. Our Expert Quilters pair it with the TinLizzie18 Extension Table. Call today to order !

Retail $62.50

Introductory Price $49.95 plus shipping. Expires 12-31-11

Filed under: Blog,TinLizzie18 News,TinLizzie18 Quilting Tips | Tags: , , ,

<< View all posts

© 2018 TinLizzie18. All Rights Reserved.   |   Site Map   |   Legal Disclaimer   |   Privacy Policy