Adjusting the Hopping Foot on the TinLizzie18

Posted by on March 24, 2017

IMG_4023

 

There are a variety of presser feet to choose from for the TinLizzie18 long arm.   The original presser foot is used for general quilting and comes with each TinLizzie18.  In addition to the original foot there is a template foot that has a higher fence and a consistent clearance around the entire foot for even stitching around any template.  Also available is a minimal open toe applique presser foot that is small and allows the quilter to easily view the quilting area.

It is important that the feet are attached and adjusted properly.  If a presser foot is too high, it may cause skipped stitches or broken thread.  If it is placed too low it may cause the machine to become out of time.  To adjust the presser feet properly follow this procedure.

Place the foot so the needle will clear it when lowered and so the screw for securing the foot is loosely connecting the foot.  You should not tighten the screw at this time.  Move the machine away from any quilt that may be on the frame.  Lower the needle to its lowest point.  You may use the needle down option.  With the needle at its lowest point, place a dime under the edge of the presser foot to make sure the foot is at the proper height and tighten the screw.  Remove the dime and raise the needle. The presser foot should be at the optimal height.  This procedure should be followed any time a presser foot is placed on the TinLizzie18.

Please note that if there is a quilt with thick seams and the presser foot is having a difficult time clearing them you may raise the presser foot temporarily to avoid the thicker seams.  Then follow the adjustments above to return the presser foot to the optimal height.

Filed under: Blog,TinLizzie18 Quilting Tips | Tags: , , , , , ,

<< View all posts

© 2017 TinLizzie18. All Rights Reserved.   |   2263 West 7800 South   |   West Jordan, Utah 84088   |   888.784.5818   |   Site Map   |   Legal Disclaimer   |   Privacy Policy